Equipment Names and Distribution Documents

A one-line diagram is a simplified representation of a power system’s sources, equipment, protective devices and connections. It does not show every conductor or physical detail. A switchboard is an assembly used to distribute power through sections containing buses and protective or switching devices. Switchgear is a broader term whose precise meaning depends on the voltage class, construction and applicable standard.

A feeder carries power from a source or distribution point to downstream equipment; a branch circuit serves loads beyond its final overcurrent protective device. A service is the connection from the serving utility to the service equipment, subject to the applicable code definition. Clear labels prevent a manufacturer and a project engineer from describing different interfaces with the same word.

Voltage, Phase and Grounding Terms

Nominal system voltage is the conventional value used to identify a system. Equipment rated maximum voltage is a limit established for the equipment under its applicable standard; the two are related but not interchangeable. Phase describes the system’s alternating-current arrangement, while the number of wires indicates the conductors provided for the specified connection.

A neutral is a conductor connected to the system’s neutral point when provided; it is not the same as an equipment grounding conductor. Grounding and bonding establish intentional connections for safety and system performance under the applicable design and code. The engineer must define the grounding scheme, neutral requirements and service bonding location for the actual installation.

Current and Capacity Terms

Ampacity describes the current a conductor or equipment component can carry under specified conditions. A main bus rating concerns the assembly’s distribution bus; a feeder device’s current rating concerns that device. Neither automatically establishes the allowable load on every downstream conductor. Ambient conditions, conductor arrangement and manufacturer instructions are among the factors requiring review.

Connected load is the sum of identified loads; calculated demand reflects applicable load calculations and assumptions about operation. Continuous load has a specific meaning under the applicable electrical code and can affect sizing. Spare breaker positions, unused physical space and reserved bus capacity are distinct provisions and should be identified separately on the drawings.

Fault Duty and Protective Devices — Switchgear and Electrical Glossary

Available short-circuit current is the prospective current at a particular point during a fault, based on system conditions. An interrupting rating describes a protective device’s ability to interrupt current at a specified voltage under stated conditions. An assembly short-circuit rating describes the assembled equipment’s suitability for fault duty under its documented conditions, not merely the rating printed on one breaker.

Withstand capability describes the ability to endure specified fault conditions for the applicable time or test duty; it is not necessarily an interrupting capability. A relay senses defined electrical conditions and initiates a response through associated equipment. A circuit breaker can open a circuit within its ratings, while a fuse interrupts overcurrent by operation of its element.

Coordination, Protection and Operating Modes

Protective coordination is the assessment of how devices operate relative to one another for overloads and faults. Selective coordination seeks to isolate the affected circuit by operation of the appropriate protective device, subject to the applicable requirements and study conditions. Device curves and settings must be evaluated with the actual system; similar ampere ratings alone do not establish selectivity.

Arc-flash analysis assesses incident energy and related working conditions using project-specific data and methods. It is not the same as an interrupting-rating or selective-coordination study, although the studies share information. Operating mode describes a source and switching arrangement, such as utility or generator supply, that can change fault levels and protection performance.

Documentation and Manufacturing Terms

A product standard specifies requirements for equipment within its scope. A listing is evidence of evaluation by a listing organization for an identified product and scope; a reference to a standard alone is not evidence that a particular assembly is listed. UL 891 may apply to relevant low-voltage switchboards, not to medium-voltage equipment generally.

A submittal is the manufacturer’s project documentation for review, commonly including drawings, ratings and component information. A shipping split divides a lineup into sections for transport and field reassembly. These definitions support discussions about new U.S.-manufactured equipment using all-American components for Nevada, but a qualified professional must verify the final design and applicable requirements.